pepperF1SH – Part XI: camera and battery mount received from shapeways

Disclosure: This post may contain affiliate links, meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

By | January 5, 2017


This post is the eleventh in a series of posts about the adventure of building the world’s lightest brushless FPV quadcopter: project pepperF1SH.

I just received the shapeways prints for my new camera and battery mount parts. The total weight is a bit lower than calculated (1.3g): The whole set weights only ~1.1grams:

This is just the white, uncolored polyamide. I am going to dye it on my own. The process is quite easy, the white shapeways prints can be colored with off the shelf cloth dye. This time the pepperF1SH is going to be YELLOW! 🙂

Leave a Reply

Your email address will not be published. Required fields are marked *